Photo By Donna M Lindner | A researcher uses Laser Bond Inspection on a large structure at the Boeing Laser Bond...... read more read more
Subscribe
WRIGHT-PATTERSON AIR FORCE BASE, Ohio – Bonded composite airframe structures offer a potential to achieve more affordable manufacturing and more efficient structures, ultimately meeting the goals of the Air Force for increased range and reduced fuel consumption.
Laser bond inspection (LBI) in conjunction with bond process control is an enabling technology to transition primary bonded composite structures and realize these goals.
Composite structures, when joined using adhesive bonding rather than traditional rivets or fasteners, require a new inspection process to verify the strength and safety of the composite bonds.
LBI is a stress test to ensure that adhesively fastened structures are joined correctly using a bond’s response to a high-energy pulsed laser generated stress wave to detect structurally substandard bonds.
A weak, improperly prepared bond will be broken by the pulse, but a standard bond will remain unchanged after pulse excitation. Substandard adhesive bonds can result from errors created by poor adhesive mixing, improper surface preparation or contamination.
LBI is the only reliable and mature method capable of assessing the integrity of adhesive bonds in composite structures and detecting kissing bonds, a bond line defect where two surfaces are in intimate contact but are not properly bonded.
“This effort is a significant progression of more than a decade of collaboration and development work by the U.S. Air Force, The Boeing Company, LSP Technologies, and additional major aerospace original equipment manufacturers,” said Andrea Helbach Structures team lead in AFRL's Materials and Manufacturing Directorate.
“However, it is far from finished. On-going efforts will prove the technology on multiple representative aircraft structures and prototype a fiber optic delivery system to increase device reach.”
Future work in this technology area includes analyzing data for bond integrity in the field. Tests also need to be done to define a wider gamut of materials, thicknesses, and joint designs so the technology can be expanded to other platforms. Additionally, hardware improvements must be made to the laser bond inspection unit for usability in a manufacturing environment.
This technology, along with a Defense Advanced Research Projects Agency program to establish bond process control, are significant steps in enabling bonded aircraft structures use in the field.
Finding new ways to save time in manufacturing and increasing aircraft range is an uphill challenge. Bonded composite structures enabled by LBI are a step in the right direction.
| Date Taken: | 02.02.2018 |
| Date Posted: | 02.02.2018 08:37 |
| Story ID: | 264392 |
| Location: | WRIGHT-PATTERSON AIR FORCE BASE, OHIO, US |
| Web Views: | 247 |
| Downloads: | 0 |
This work, Air Force collaboration could increase use of composites in aerospace manufacturing, by Donna M Lindner, identified by DVIDS, must comply with the restrictions shown on https://www.dvidshub.net/about/copyright.
No keywords found.
